Instructions

Triggercam Basic Start Guide

INSTRUCTIONS VIDEO



STEP BY STEP GUIDE

STEP 1:

Select and fit the required insert over your riflescope eyepiece. There should be a gap of approximately 2mm.

STEP 2:

Slide the correct insert into the TRIGGERCAM so that the insert slot is aligned with the slot of the TRIGGERCAM

STEP 3:

Mount the TRIGGERCAM over the riflescope eyepiece and slightly tighten the mounting screw until the TRIGGERCAM is fixed to your riflescope.

STEP 4:

Switch on the TRIGGERCAM. Press and hold the power button for 2 seconds. Power button (red arrow) Wi-Fi button (blue arrow). To switch on the Wi-Fi. Press and hold the Wi-Fi button for 2 seconds.

STEP 5:

Connect to the TRIGGERCAM WI-FI network on your mobile device. The password for the camera is 12345678.

STEP 6:

Search for TRIGGERCAM on Google play or the App store and download the app for your mobile device. Connect to your camera through the mobile app.

STEP 7:

Remove the focus cap with the TRIGGERCAM tool.

STEP 8:

After mounting, the next step is to focus the TRIGGERCAM for your specific riflescope. Ensure your riflescope is set on the desired magnification preferred, and aim on a target at the distance on which your rifle is zeroed e.g. 100 metres. Through using the live streaming function on the app turn the focus until the image is clear.


[TIP: Focus your TRIGGERCAM on a high magnification, if you then move to lower magnification it will remain in focus. If you focus on a low magnification and want to move higher, it will lose focus faster.]

STEP 8: (continue)

Grey arrow – Focus Ring

Blue arrow – Charge Port

Red arrow – SD Card

Image not in focus

Image in focus

STEP 9:

Once your device is focussed, set the orientation of the camera so that the crosshairs are perfectly aligned. This can be done through live streaming function on your smart phone (SEE INSTRUCTIONS OF STREAMING BELOW).

STEP 10:

Your TRIGGERCAM is now ready!!!

IMPORTANT INFORMATION

Recording can be done on either the TRIGGERCAM itself or via the TRIGGERCAM smart phone app. After the TRIGGERCAM is switched on, push the ON button until the beep sound is heard, the TRIGGERCAM is now recording. This recording is saved on the SD card that is inserted in the TRIGGERCAM. To stop the recording, push the ON button again until the beep sound is heard.

The red light indicates that your TRIGGERCAM is charging when plugged in. When the red light changes to green,your unit is fully charged.

The moment your TRIGGERCAM is switched on the blue light will show. When pressing the ON button again the TRIGGERCAM starts recording (green light) on the SD card in the unit. By pressing the ON button again, recording is stopped, and the GREEN light will disappear.

Battery life of your Triggercam: 2 hours recording time. Tip: to get longer battery operational time switch your triggercam on & off between hunting sessions or connect a portable power bank to your unit.